Durable mesh belt conveyor, a grand national bestseller, net belt conveyor belt conveyor deviation and handling conveyor belt running deviation is one of the most common faults. There are many reasons for deviation, the main reason is to install low precision and routine maintenance is poor. During installation, between the head and tail rollers, idlers as far as the middle of the same center line and parallel to each other, in order to ensure that the conveyor belt is not biased or less biased. In addition, the tape tabs to the right, should be the same on both sides of the perimeter. During use, if there is deviation, will have to make the following checks to determine the cause, make adjustments. Belt Deflection always check the location and processing methods are: 1. Check the lateral misalignment roller conveyor belt centerline longitudinal centerline. If you do not coincide value exceeds 3mm, you should take advantage of the elongated mounting holes on both sides of idlers be adjusted. The specific method is biased which side of the conveyor belt, which the lateral direction of the conveyor idlers advance forward, or move after the other side. 2. Check the head, tail rack-mounted bearing deviation of the value of the two planes. If the deviation is greater than two planes 1mm, then adjusted in response to the two planes in the same plane. Adjustment of the head drum is: If the roller conveyor deviation to the right, then the bearing roller should be moved forward to the right or left side of the bearing seat backward; if the conveyor roller deviation to the left, then bearing roller should be moved forward on the left or right side of the bearing after the shift. Rear roller adjustment methods and the head drum opposite. 3, check the location of the material on the conveyor belt. Material is not centered on the conveyor cross-section, will lead to the conveyor belt deviation. If the material is biased to the right, then the belt deviation to the left, and vice versa. In should be used as much as possible so that the material in the middle. To reduce or avoid such blocking plate conveyor deviation increase, change direction and position of the material. Ning County grand network chain Manufacturing Co., Ltd. Contact: Li Tel: 0534-5231116 / 0534-5231118 Fax: 0534-5535288 / 0534-5231117 Mobile: 13853443679 E-mail 15066638681/18865797888: njsdwl@sina.com Address: Shandong Province Ning Jin Qi County Development Zone Website: www.sdwdwl.com